Every long-lasting floor starts with proper preparation. We handle the full scope of substrate work — grinding, removal, repair, and moisture control — so your coating bonds perfectly and lasts for decades.
Skipped prep is the #1 reason DIY and budget coatings fail early. We never cut corners.
Diamond grinding, shot blasting, and mechanical surface profiling to prepare concrete for coatings. HEPA-filtered dust collection.
Remove failed epoxy, polyurea, paint, adhesives, mastic, thinset, and other coatings down to bare concrete.
Epoxy injection, semi-rigid joint fillers, spall repair, and control joint restoration for structural and cosmetic fixes.
ASTM F2170 moisture testing, vapor barrier systems, and moisture-mitigation primers to stop slab moisture from damaging coatings.
Whether it's epoxy, polyaspartic, quartz, or polished concrete — the long-term success of every floor depends almost entirely on what happens before the coating goes down. Moisture trapped in the slab, old coatings that weren't fully removed, or a surface that wasn't properly profiled will eventually cause delamination, peeling, or blistering — no matter how expensive the coating material.
Concrete is porous and can trap moisture, old sealers, curing compounds, oil, and contaminants deep below the surface. Standard cleaning won't remove these. Diamond grinding, shot blasting, and moisture testing are the only reliable ways to ensure a sound bond — and they require professional equipment and experience.
We assess concrete condition, test for moisture, and identify any existing coatings or contaminants.
Diamond grinding, shot blasting, or coating removal to create a clean, properly profiled surface.
Cracks, joints, spalls, and moisture issues are addressed before any coating is applied.
With the substrate properly prepared, your chosen coating system bonds for maximum lifespan.
Common questions about surface preparation and concrete repair
The only reliable way to know is ASTM F2170 relative humidity testing. We insert probes into the concrete to measure moisture vapor emission rates. If levels exceed the coating manufacturer's limits, we recommend a moisture-mitigation system before any coating goes down.
Get a free consultation and assessment of your concrete's condition before any coating is applied.